Commercial › Warehouse
Warehouse Floor Coating in Granbury, TX
Industrial epoxy and quartz flooring for warehouses, distribution, and manufacturing across Granbury, Weatherford, Stephenville, Glen Rose, Aledo & the southwest Fort Worth area. Big slabs, hard use, and no room in the schedule to shut down. We grind, test the concrete for moisture, and build the system your traffic actually calls for.
Start with the slab
On a warehouse floor, moisture decides everything
Warehouse slabs are the hardest floors to guess at. They are large, usually poured on grade, frequently without a vapor barrier underneath, and often decades old.
Water vapor moves up through concrete from the soil below it. When it reaches a coating and has nowhere to go, it collects underneath and pushes the coating off the slab. On a garage that is a nuisance. On sixty thousand square feet it is a catastrophe.
So we grind a section and meter the concrete before we commit to a system. That reading matters more than any preference, because coating systems have published moisture limits and the thicker builds tolerate substantially more vapor than the thin ones. If your slab reads high, that fact chooses your floor, and we would rather find it in the quote than in a warranty claim.
Be honest about the traffic
Matching the system to your warehouse traffic
This is the question that decides your system, and it is the one most floor companies skip past. There is a wide gap between a floor that sees carts and foot traffic and one that sees loaded forklifts on hard wheels all day.
Foot traffic, carts, pallet jacks
Storage areas, packing and QC zones, back-of-house, staging. An epoxy flake system or a single-broadcast quartz floor handles this well. You get a seamless, sweepable, sealed floor that brightens the building and stops the concrete dusting onto everything.
Steady equipment traffic
Regular forklift and machinery use through defined lanes. This moves you toward a heavier build, a double-broadcast quartz or a thicker aggregate system, because there needs to be more material between the wheels and your slab.
Heavy, constant forklift traffic
Loaded lifts on hard wheels, all day, across joints. Here we will tell you something a lot of coating companies will not: the manufacturers themselves specify much thicker aggregate-filled systems or urethane cement for this duty, not a standard broadcast floor. If that is your operation, we would rather scope it correctly or tell you it is outside what we install than sell you a floor that fails in year two.
Keeping you open
Coating a warehouse floor without shutting down
Almost no warehouse can hand over the whole floor at once. So we do not ask for it. We break the floor into sections, coat one, let it cure, and move on, building the sequence around your dock doors, your racking, and where your traffic has to flow.
It takes longer overall and adds some mobilization cost compared with doing it in one shot. For most operations that is still far cheaper than the alternative. What we need from you is honest information about your hours, your busy season, and which areas cannot be down at the same time.
One thing worth planning for: foot traffic returns well before equipment traffic does, and equipment is the long pole. Rushing a forklift onto a floor that has not cured is one of the few ways to ruin a new coating in its first week. You get the return-to-service schedule in writing so nobody has to guess.
What goes down
Warehouse floor coating systems
Epoxy flake
High-build epoxy base, full flake broadcast, polyaspartic topcoat. Bright, seamless, hides wear, easy to sweep and scrub. A strong fit for storage, packing, and back-of-house areas. See the colors.
Quartz broadcast
Colored quartz granules instead of vinyl flake. Harder mineral, heavier build, more grip. Single broadcast for light to medium traffic, double for heavier duty and for slabs with higher moisture readings. See quartz colors and the build difference.
Stain & seal
Grind, stain, seal. No build, just the concrete finished and protected. The most affordable way to cover a lot of square footage when the floor needs to look finished and shed dust rather than take a beating. stained concrete floors.
Tell us the square footage and what runs on it
Those two facts plus a moisture reading get you a firm number. We walk warehouse floors across Granbury, Weatherford, Stephenville, Glen Rose, Aledo & the southwest Fort Worth area and put the system, the sequence, and the schedule in writing before you commit to anything.